SVOLT CL33

正常工作的单体电芯25± 3 °C,50% SOC状态下,最大脉冲放电电流942A,电芯温度低于50 °C,且最长放电时间为10 s。 The maximum current of 10s pulse discharge is 942A at 50%SOC at 25± 3°C, and the cell temperature shall not exceed 50 °C.1.4.5 绝对放电温度 Absolute charge temperature 持续放电模式或脉冲放电模式,若电芯温度超过绝对放电温度 -30~55 °C,则停止放电。 No matter what discharging mode (continuous or pulse discharge), the discharge will cut off immediately once the cell temperature exceeds -30°C-55°C.1.5 脉冲放电模式 Pulse discharge specification 是指在产品使用过程中,电芯进行脉冲放电。脉冲放电必须严格符合本产品标准所述的充电状态和电芯温度条件。脉冲电流的大小和持续时间必须严格遵守下表所列的所有充电状态以及电芯温度等条件。违反脉冲放电条件可能会造成电芯永久性的损坏并进而免除SVOLT 的产品质量责任。 During discharge, the current isn’t constant and changes in certain range with time. Pulse discharge must strictly comply with the charge state and temperature conditions of cells described in this specification. The value and continuous times of the pulse current must be also in stri ct accordance with the charge state and temperature conditions listed in table below. Violation of pulse discharge conditions may cause permanent damage to the cell and thereby exempt product quality responsibility of SVOLT.1.5.1 最小脉冲放电截止电压 Minimum pulse discharge limit voltage -30°C≤T≤55 °C

Source version: V · Page 13

43.67 A(1/3C) DC to 2.0V 1.1.8 工作温度(充电) Operating temperature (Charge) -20 ~ 55°C 参考第 1.2、1.3 节 Refer to 1.2, 1.3 1.1.9 工作温度(放电) Operating temperature (discharge) -30 ~ 55°C 参考第 1.3.1、1.5 节 Refer to 1.4, 1.

Source version: V · Page 7

2、1.3 节 Refer to 1.2, 1.3 1.1.9 工作温度(放电) Operating temperature (discharge) -30 ~ 55°C 参考第 1.3.1、1.5 节 Refer to 1.4, 1.5 1.1.10 循环寿命 Cycle life ≥2500 25°C, Step charge/1C, 3 -100%SOC, 80%SOH 1.1.11 室温放电功率 discha

Source version: V · Page 7

ACR(1KHz) ≤0.65mΩ 25°C, 新电池 21%SOC 状态 25°C, BOL, 21%SOC

Source version: V · Page 7

3% - 100% N.A.1.1.14 电池重量 Cell weight 2350± 35 g N.A.

Source version: V · Page 7